Outdoor Great Room Intrigue Table Fire Pit - Manual (Page 12)

Page | 12 Intrigue 90215 REV E 6/7/2012
Step 6 :

Insert two (2) D Batteries into battery pack.

The wires connecting the battery pack to the
control module can be bundled and secured
with the included optional cable tie if desired
OR they can be left loose so that the battery
pack can be separated from the unit and
pulled out to the edge (as shown at right) for
table configurations that make it difficult to
replace batteries while they’re mounted
under the table.
Step 7:
Moving now to the top side of your table,

Remove the nuts from the threaded
rods (at right)

Set the Venturi Top on the Burner
Module lining up the threaded rods
with the holes in the underside of
the Venturi Top

Thread nuts back onto the threaded
rods and tighten to secure
7
a
.
Step 8:

Wearing clean, soft leather gloves and
eye protection to avoid accidental
injury while handling glass, using a wet
cotton swab, paper towel or similar,
wet the gasket to ease glass
installation.

Carefully rock glass cylinder into place
until it contacts metal base and sits flat
and level.
-OR-
6.
7
b
.
8
a
.
8
b
.