B&C Technologies IM Series Industrial Ironer - Manual (Page 90)

_____________________________________________________________________
Revision Number: 1
Revision Date: 09/18/07 4 of 4 Paratherm HE
SECTION 15 REGULATORY INFORMATION
United States
RCRA Hazardous Waste Number and Classification: Not applicable
TSCA Inventory Status: Included
SARA Title III Section 313 and 40 CFR 372: Not subject to reporting requirements
Clean Air Act Section 112: Not classified as a Hazardous Air Pollutant (HAP)
California Proposition 65: This product does not contain materials which the state of California
has found to cause cancer, birth defects, or other reproductive harm.
International
Canada (WHMIS): Not controlled
This material is listed on the following inventories;
Australia (AICS)
Canada (DSL)
China
Europe (EINECS)
Korea (Existing and Evaluated Chemical Substances)
Philippines (PICCS)
Japan (ENCS)
SECTION 16 OTHER INFORMATION
Recommended Use: Heat transfer agent
Date of Revision: 9/18/07
Reason for Revision: New
NFPA RATINGS: Health: 0 Flammability: 1 Reactivity: 0
0-Least, 1-Slight, 2-Moderate, 3-High, 4-Extreme
Abbreviations that may have been used in this document
TLV - Threshold Limit Value TWA - Time Weighted Average
STEL - Short-term Exposure Limit PEL - Permissible Exposure Limit
IDLH Immediate Danger to Life and Health CAS - Chemical Abstract Service Number
NOHSC Nat’l Occup. Health & Safety Comm. TLV Threshold Limit Value
< - Less Than > - Greater Than
<= - Less Than or Equal To >= - Greater Than or Equal To
Prepared according to the OSHA Hazard Communication Standard (29 CFR 1910.1200) and the ANSI MSDS Standard Z400.1).
The above information is based on the data of which we are aware and is believed to be correct as of the date hereof. Since this
information may be applied under conditions beyond our control and with which we may be unfamiliar and since data made
available subsequent to the date hereof may suggest modifications of the information, we do not assume any responsibility for the
results of its use. This information is furnished upon condition that the person receiving it shall make his own determination of the
suitability of the material for his particular purpose.
80