Dell PowerEdge 4350 - Manual (Page 38)

Table 3-2. System Beep Codes (continued)
Code Cause Corrective Action
1^-2
1-3-3
1-3-4
No memory installed
Chip or data line failure in
the first 64 KB of main
memory
Odd/even logic failure in
the first 64 KB of main
memory
Remove and reseat the DIM Ms. If the
problem persists, replace the DIMMs. See
"Adding Memory" in Chapter 8 for instruc­
tions on installing or removing DIMMs. If
the problem still persists, replace the sys­
tem board. See Chapter 12, "Getting
Help," for instaictions on obtaining techni­
cal assistance.
1-4-1 Address line failure in the
first 64 KB of main
memory
1-4-2 Parity failure in the first
64 KB of main memory
2-1-1
through
2-4-4
Bit failure in the first
64 KB of main memory
3-1-1
3-1-2
Slave DMA-register
failure
Master DMA-register
failure
Replace the system board. See
Chapter 12, "Getting Help," for instruc­
tions on obtaining technical assistance.
3-1-3 Master interrupt-mask
register failure
3-1-4 Slave interrupt-mask
register failure
3-2-4 Keyboard-controller test
failure
Check the keyboard cable and connector
for proper connection. If the problem per­
sists, run the Keyboard Test Group in the
Dell Diagnostics to determine whether the
keyboard or keyboard controller is faulty.
See Chapter 5, "Running the Dell Diagnos­
tics." If the keyboard controller is faulty,
replace the system board. See Chapter 12,
"Getting Help," for instructions on obtain­
ing technical assistance.
3-3-1 CMOS failure Run the System Set Test Group in the Dell
Diagnostics to isolate the problem. See
Chapter 5, "Running the Dell Diagnostics."
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and
acronym list that precedes the Index.
3-10 Dell PowerEdgetSSO ^sterns Installation and Troubleshooting Guide