Welch Allyn GCX M-Series Wall Mount Kit for Welch Allyn Propaq CS Monitor - Installation Guide - Manual (Page 3)

DU-PR-0013-06 Rev A 2/28/07 GCX Corp Page 3 of 5
5. Remove four (4) existing screws from rear of monitor (right). These mounting
holes will be used for attachment of Sub Plate in step 6.
6. Ensure four (4) standoffs on Sub Plate are facing away from the monitor (see below), and fasten Sub Plate to rear of
monitor with four (4) #6-32 x 3'' PHMS as shown below.
7. Fasten Mounting Adapter to standoffs on Sub Plate with four (4) #8-32 x 1/4'' PHMS and #8 flat washers.
#6-32 x 3'' PHMS (4)
Sub Plate Standoffs (4) Must
Face Away from Monitor
Remove Existing Screws (4)
#8-32 x 1/4'' PHMS (4)
#8 Washers (4)
Mounting Adapter
Standoffs (4)
Standoffs (4)
Sub Plate