Welch Allyn GCX M-Series Wall Mount Kit for Welch Allyn Propaq CS Monitor - Installation Guide - Manual (Page 2)

DU-PR-0013-06 Rev A 2/28/07 GCX Corp Page 2 of 5
4 – Slide Adjustable Stop to Bottom of Channel
Slide and Tighten Center Screw in Stop.
2 – Slide Basket to Mounting Position, and
Tighten Set Screw with 1/8'' Hex Wrench.
3 – Slide Arm to Mounting Position, and
Tighten Set Screws with 1/8'' Hex
Wrench.
Refer to Photo Below for Steps 2 - 4:
2. Install the Basket by inserting Slide (rear of Basket) into top of Channel and sliding Basket to desired mounting
position. Using the 1/8'' hex wrench provided, tighten the set screw in the bottom right corner of the Slide.
3. Insert Adjustable Stop in top of Channel and let it slide to rest against top of Basket Slide.
4. Install Arm by guiding Slide (rear of Arm) into top of Channel. Slide Arm to desired position in channel and tighten two
(2) set screws (bottom of Slide) using 1/8'' hex wrench provided. Slide Adjustable Stop to bottom of Arm Slide and
tighten center screw in Adjustable Stop.