Welch Allyn Connex Vital Signs Monitor, Radio Software Configuration - Installation Guide - Manual (Page 8)

8 80018044 Ver B Welch Allyn
e. Touch Radio.
2. Select WPA2-AES in the Authentication type menu.
3. Select TTLS or PEAP in the EAP Type menu.
4. Enter your EAP identity. The default identity is “vitalsigns.”
5. Enter your EAP password. The default password is “password.”
6. Click Configure radio.
To use EAP-TTLS or PEAP-MSCHAPv2 with only a server certificate, do the
following:
1. Load the CA certificate chain as described in “Loading customer certificates” on
page 6. However, skip Step 3 .
2. Select the EAP settings page and check the box next to Verify Server Certificate.
3. Verify that the device’s date and time are correct and fall within the validity date and
time of your certificate.
4. Access the radio configuration settings on your device.
a. Touch Settings.
b. Touch Advanced.
c. Enter 6345 in the Advanced setting code field and touch OK.
d. Touch Network.
e. Touch Radio.
5. Select WPA2-AES in the Authentication type menu.
6. Select TTLS/PEAP in the EAP Type menu.
7. Enter your EAP identity. The default identity is “vitalsigns.”
8. Enter your EAP password. The default password is “password.”
9. Click Configure radio.
To use EAP-TTLS or PEAP-MSCHAPv2 with both server and client certificates, do the
following:
1. Load the certificates as described in “Loading customer certificates” on page 6.
2. Select the EAP settings page and check the box next to Verify Server Certificate.
3. Verify that the device’s date and time are correct and fall within the validity date and
time of your certificate.
4. Access the radio configuration settings on your device.
a. Touch Settings.
Note DO NOT select your EAP Type through the radio configuration tool user interface.
Use the Advanced settings screen on your device.
Note DO NOT select your EAP Type through the radio configuration tool user interface.
Use the Advanced settings screen on your device.