Welch Allyn Electrosurgical Unit - User Manual - Manual (Page 9)

d. If the use of other output modes is anticipated, repeat steps (a) and (b) as
desired. The output power level settings selected for each output mode are
retained as long as the unit remains ON.
2. GUIDELINES FOR POWER SETTINGS
The following guidelines for power settings may vary due to the technique, clin-
ical circumstances, accessory style, cutting wire diameter, size, configuration
and user preference.
NOTE: * If the cut mode is desired, use the recommended settings for the
blend mode.
+ As required, increase the power setting beyond 56 to coagulate
any bleeding points.
REMEMBER, THIS IS NOT AN ATTEMPT TO TEACH ELECTROSURGICAL TECHNIQUE.
Inexperienced practitioners should not attempt the procedures described below
based solely on this information; instead, acquire the skills required in the time-hon-
ored preceptor manner. NOTE: The best initial effect is accomplished with the cut-
ting wire in only light contact with tissue. Tight pressure may cause desiccation of
the tissue and will delay the start of the cutting effect.
IMPORTANT
The initial use of any electrosurgical generator always involves some degree
of “trial and error”. This is true even when only changing from numbered
dials to digital display models within the same manufacturer’s product line.
As with any other therapeutic device, it is very helpful to experiment IN
VITRO or on animal sample tissue before using any electrosurgical genera-
tor or methods which are not familiar.
The microprocessor control system of this unit was developed specifically
to provide the best possible performance for Loop electrosurgical excision
procedures. By exhibiting patience and following the guidelines offered, the
practitioner should easily become familiar with the performance character-
istics of the Electrosurgical Unit.
I. PROFESSIONAL USE GUIDE (cont.)
1.0
22-36 30-40 34-36
30-36
14-24
40-56 +
1.5 Macro Micro 2.0
Recommended Power Settings (Watts)
for the Welch Allyn Electrosurgical Electrodes
8
Electrosurgical Unit • Instruction Manual