Welch Allyn Cardioperfect PRO ECG Recorder - User Manual - Manual (Page 11)

CardioPerfect
PRO ECG Recorder - User Manual
DIR 80012763 Ver. F 11 / 26
1. About the CardioPerfect Pro Cardiograph
The Welch Allyn CardioPerfect Pro Cardiograph is specifically intended for the recording of
standard 12-lead electrocardiograms of patients. The device is not suitable for direct cardiac
application.
A CardioPerfect Pro system typically comes with the following components:
CardioPerfect Pro Cardiograph (SE-PRO-600, -1200)
Patient Cable (RE-PC or SE-PC)
PC Interface Cable Prolink (PRO-60023, -24, -25)
Battery Pack (PRO-60019)
CardioPerfect Workstation Software (CPWS-SW)
Caution
The patient cable supplied with the CardioPerfect cardiograph is an
integral part of the cardiograph’s safety features. Using any other
patient cable may compromise defibrillation protection as well as
cardiograph performance. The patient cable should be routed away
from power cords and any other electrical equipment. Failure to do
so can result in AC power line frequency interference on the ECG
trace.
Warning
Do not touch the patient, patient cable, PC interface cable (Prolink)
or cardiograph during defibrillation. Death or injury may occur from
the electrical shock delivered by the defibrillator. It is recommended
to check the patient cable and PC interface cable (Prolink) for
damage prior to the use of the system. If damage exists do not use
the cable, contact your local Welch Allyn Sales Office or your
authorized Welch Allyn dealer or distributor to have the cable
replaced.