Welch Allyn OSZ 3 Easy - User Manual - Manual (Page 17)

Directions For Use 9
5.4. Measuring procedure
After the cuff has been appropriately positioned, the
measurement can begin:
1. Press the O/l-button, the pump
begins to inflate the cuff. In the
display, the increasing cuff-
pressure is continually displayed.
2. After reaching the inflation
pressure, the pump stops and the pressure
slowly falls away. The cuff-pressure (large
characters) is displayed during the
measurement. When the device has detected
the pulse, the heart symbol in the display
begins to blink and a beep tone is audible for
every pulse beat.
3. When the measurement has been concluded,
a long beep tone sounds. The measured
systolic and diastolic blood-pressure values as
well as the pulse frequency are now displayed.
Example (Fig.): Systole 118, Diastole 73, Pulse 75
The measurement results are displayed, until you
switch the device off. If no button is pressed for 5 minutes, the
device switches automatically off, to save the batteries.