Welch Allyn Connex VM data management system - User Manual - Manual (Page 35)

Troubleshooting
Why isn't the workstation communicating with the server?
Possible cause Corrective action
When I open the Connex VM program, I get an error
message.
Contact your network administrator or IT resource.
The wireless network connection has been lost. Adjust the computer's position to a location where
there is a known network connection. The system will
attempt to reconnect until it is successful.
The network is down; a path to the server cannot be
found.
Check other software for the same difficulty, and
notify your network administrator or IT resource.
The server is down. Contact your network administrator or IT resource.
The computer is not connected to the network. Contact your network administrator or IT resource to
connect the computer to the network.
Why isn't the wired device communicating?
Possible cause Corrective action
The device is turned off or unplugged. Turn on or plug in the device.
The connectivity cable is unattached from the device
or the computer.
Attach the cable to the device and the computer.
The connectivity cable is damaged. Use another cable to transfer the data.
The device has been replaced with another device. Exit the Connex VM program, unplug the cable,
reattach, and then restart the program.
The Connex VM system does not recognize the
device.
In the bottom right corner of the Connex VM window,
right-click the phrase No device connected ,
and then click Refresh devices . The message
changes to Device connected .
31