Vintage Cellars 1800 Series CellarPro - Manual (Page 16)

16
6. If your wine cabinet has three pieces of foam located on the bottom and on each
side of the black metal bracket that supports the rear of the cooling unit (attached
to the rear wall in most top-vented units), place these foam pieces along the
bottom and sides of the metal bracket.
7. Install the cooling unit by following the removal instructions described above in
reverse.
8. A complete and proper seal must be made between the cellar and the cooling unit
to ensure that outside air does not enter the cellar. Use butyl adhesive tape to
seal the perimeter where the cooling unit touches the cellar by rolling the tape
with your fingers into a thin (pencil diameter) "rope", then press the tape into the
cracks where the cooling unit touches the cellar.
9. Check the seal by having a helper stand in front of the cabinet while you shine a
flashlight around the cooling unit edges to discover any gaps in sealant.
10. Wait 24-hours before running the cooling unit. We recommend plugging the
cooling unit into an outlet with a dedicated 15-amp circuit and a surge protector.
RETURNING THE ORIGINAL COOLING UNIT:
If the original cooling unit is under warranty and you are returning it, please follow the
instructions below:
1. Use the original packaging to repack the cooling unit.
2. Make sure that the cooling unit is upright in the box
3. The exterior of the box should be prominently marked with “This Side Up” and
“Fragile” for the freight carrier