Vintage Cellars WhisperKOOL InCellar - Manual (Page 17)

www.whisperkool.com | Page 15
Drain Line
During operation, the cooling unit will strip
excess condensate from the air in order to
maintain the proper level of humidity within the
cellar. Thus the drain line will prevent overflow
and leaking by allowing for discharge of the
additional condensate.
Connect the Drain Line Tube to the Drain Port on
the Top of the Cooling Unit. Routing the Drain
Line to the attic and then to a dispense area is
recommended. The InCellar Cooling Unit will
Pump the excess condensate through the Drain
Line Tube.
Do not rout the drain line more than 30 vertical ft.
If the outlet of the drain line is below the base of
the unit, install the anti-siphon device as shown
in (Figure 5).
Failure to install the drain line voids the warranty.
To prevent mold from growing, allow the drain
line to hang above the water line.
Condensation Drain Line Tube
The condensation drain line tube is used to remove excess condensation from the unit to a proper discharge location.
It is important that the drain line tube is properly connected and used to prevent leakage and other problems
associated with excess condensation.
Failure to use the condensation drain line tube will void the warranty on the unit.
DRAIN LINE
WRONG: Drain line is under water.
FIGURE 5
Anti-Siphon
Device