Vintage Cellars Platinum Split Fully Ducted 4000WC - Manual (Page 27)

www.whisperkool.com | Page 25
PREPARING THE CONDENSING UNIT
Electrical Needs
The condensing unit requires a dedicated 115 volt, 20 amp circuit. A dedicated circuit breaker ensures that the
condensing unit will have sufficient power for effective operation. The compressor is controlled by a low pressure
switch mounted on the condensing unit. This feature eliminates the need for wiring between the evaporator and
condensing unit.
• Provide an outlet for the condensing unit that matches the plug provided on the unit
• Ensure the voltage supplied matches the rating specified on the unit spec label
• Provide a weatherproof disconnect for condensing units located outside
As with all sensitive electrical equipment, damage may be caused in the event of power surges and spikes.
WhisperKOOL recommends plugging the unit into a surge protector, or power conditioner in order to protect your
system. As outlined in our Terms & Conditions, power surges and spikes are not covered under warranty.
In case the system should lose power, check the home/main circuit breaker. If the system does not respond properly,
refer to the Troubleshooting section on page 34.