Vintage Cellars CellarPro Owners Manual User Manual

Page 15

11. After installing the cooling unit, It is not necessary to replace the grill

12. A complete and proper seal must be made between the cellar and the cooling unit

to ensure that outside air does not enter the cellar. Use the butyl tape to seal the
perimeter where the cooling unit touches the cellar at the rear of the cellar by

rolling the tape with your fingers into a thin (pencil diameter) "rope", then press the
tape into the cracks where the cooling unit touches the cellar.

13. Check the seal by having a helper stand in front of the cabinet while you shine a

flashlight around the cooling unit edges to discover any gaps in sealant.

RETURNING THE ORIGINAL COOLING UNIT:

If the original cooling unit is under warranty and you are returning it, please follow the
instructions below:

1. Use the original packaging to repack the cooling unit.

2. Make sure that the cooling unit is upright in the box

3. The exterior of the box should be prominently marked with “This Side Up” and

“Fragile” for the freight carrier