Vintage Cellars CellarPro Owners Manual - Manual (Page 12)

11
8. Attach the mounting clips to the new cooling unit so that they line up with the
holes in the cellar. First, remove the front grill (attached with two screws on each
side of the cooling unit), attach the mounting clips and then replace the front grill.
9. Some cellars have three pieces of foam located on the bottom and on each side
of the bracket that supports the back of the cooling unit. These foam pieces
should be placed in their original locations
10. Follow the removal instructions described above in reverse.
11. After installing the cooling unit, It is not necessary to replace the grill
12. A complete and proper seal must be made between the cellar and the cooling unit
to ensure that outside air does not enter the cellar. Use the butyl tape to seal the
perimeter where the cooling unit touches the cellar by rolling the tape with your
fingers into a thin (pencil diameter) "rope", then press the tape into the cracks
where the cooling unit touches the cellar.
13. Check the seal by having a helper stand in front of the cabinet while you shine a
flashlight around the cooling unit edges to discover any gaps in sealant.
RETURNING THE ORIGINAL COOLING UNIT:
If the original cooling unit is under warranty and you are returning it, please follow the
instructions below:
1. Use the original packaging to repack the cooling unit.
2. Make sure that the cooling unit is upright in the box
3. The exterior of the box should be prominently marked with “This Side Up” and
“Fragile” for the freight carrier