Canon VB-C60B - Manual (Page 74)

2-16
Maximum left/right captured area
Tilt contr
ollab
le area
maxim
um up/do
wn capture area
Maximum wide-angle viewing angle
Pan controllable area
Note
● When changing settings for camera’s installation conditions, you need to recapture
a panorama image and register again.
● Panorama Preview may be slightly different from the actual picture. You need to
check if the view restrictions are correctly reflected in VB Viewer after the view
restrictions have been set.
● You should use VB Viewer when confirming the setting. (view restriction is not
applied in Admin Viewer.)
● If changing the setting of Image Stabilizer after View Restriction settings, the view
restriction area may be different between when it is set and when it is actually used
(
→ P.3-20).
● When changing Image Stabilizer or Digital Zoom setting, you need to reconfirm
the view restriction.
Tip
● Even when view restriction is set, if the camera is controlled to capture near the
boundary of the view restrictions, the restricted area may be momentarily captured.
● To release view restriction, clear the “Apply the view restriction” check box and
then click “Apply” and “Save View Restriction”.
● When the value is blank while “Apply the view restriction” is checked, the maximum
view restriction value is used.
● The controllable area and captured area are as follows:
View Restriction Tool