Rice Lake IQ plus 590-DC Installation Manual - Manual (Page 16)

12 IQ plus 590-DC Installation Manual
3.1.3 Front Panel Configuration
The IQ plus 590-DC indicator can be configured using a series of menus accessed through the indicator front
panel when the indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
Figure 3-2. Front Panel Key Functions in Setup Mode
Menu Menu Function
CONFIG Configuration Configure grads, zero tracking, zero range, motion band, overload, tare function, sample rate,
and digital filtering parameters.
FORMAT Format Set format of primary and secondary units, display rate.
CALIBR Calibration Calibrate indicator. See Section 4.0 on page 23 for calibration procedures.
SERIAL Serial Configure serial port.
PROGRM Program Set power-up and standby modes, counting scale functions, regulatory mode, unit ID and
consecutive number values.
P FORMT Print Format Set print format used for gross, net, and counting scale tickets. See Section 7.0 on page 31
for more information.
VERSION Version Display installed software version number.
Table 3-1. IQ plus 590-DC Menu Summary
T
4
9 0 8
5 2
7 6
3
CLEAR
DISPLAY
TARE
ZERO GROSS
NET
TARE UNITS PRINT
B/N Units
POWER
ENTER SAMPLE MODE PRINT
I / O
Move LEFT /
Previous
Move RIGHT /
Next
Move UP /
Increment Value
Move DOWN /
Decrement Value
ENTER Value
SETUP MODE KEY FUNCTIONS
T