Rice Lake Lift Truck/Pallet Jack Scales - Intercomp PW800 - Manual (Page 15)

PW800, Users
Rev O, January, 2008
15
2: The IZSM (initial zero setting mechanism on power up) must be within +/- 10%
of the zero obtained at calibration.
3: The push-button zero and AZSM can only operate within +/- 2% of the IZSM.
4: The over-capacity point is 103% of capacity above the IZSM.
18. The scale shows “EE-10 EE-10 EE-10 EE-10”. Press the NET/GROSS and MODE keys. The scale
shows the current 'Initial zero range' setting. Use the following table to select the
'Initial zero range' setting:
Setting Initial zero range
0 Off
1 On
A '0' setting implies: The initial zero setting mechanism (IZSM) will work over the
entire range of the scale capacity and the over-capacity point is 103% above the
zero obtained at calibration.
A '1' setting implies: The IZSM must be within +/- 10% of the zero obtained at
calibration and the over-capacity point is 103% above the IZSM.
19. The scale shows “EE-11
EE-11 EE-11 EE-11”. Press the NET/GROSS and MODE keys. The scale
shows the current graduation selection. Use the following table to select a
graduation value.
Settings Count by in lb Count by in kg
0 100 50
1 50 20
2 20 10
3 10 5
4 5 2
5 2 1
6 1 0.5
7 0.5 0.2
8 0.2 0.1
9 0.1 0.05
10 0.05 0.02
11 0.02 0.01
20. The display shows “EE-12
EE-12 EE-12 EE-12”. This parameter is reserved for future use. Press
NET/GROSS and MODE keys together twice to continue.
21. The scale shows “EE-13
EE-13 EE-13 EE-13”. Press the NET/GROSS and MODE keys. The display
shows the current circuit board ID#. This is used in multi scale applications. The
circuit board ID is used for identification.