Rice Lake EL232 XPCD Explosion Proof Remote Serial Display - Manual (Page 17)

Indicator Setup 13
Any device that has a programmable ASCII output can be used with the EL232 XPCD. Set the device to emulate
any of the following:
3.1.1 Condec Data Format
Figure 3-1 shows the Condec UMC series continuous output data format.
Figure 3-1. Condec Continuous Output Data Format
3.1.2 Electroscale Data Format
Figure 3-2 shows the Electroscale continuous output data format.
Figure 3-2. Electroscale Continuous Output Data Format
Masstron M2500, M5000 Continuous 4800 -
Fairbanks 90-164 Continuous current loop via
port C 1200 -
Streeter Amet 9000 Current loop 1200, 2400, 9600 -
Cardinal 738 Current loop or RS232 using
S3=10000100 1200 to 9600 See Figure 3-4
Generic smart
receiver N/A RS232 or current loop 1200 to 9600 Can receive serial data in a
wide variety of intuitive
formats. Use when all else
fails.
Brand Model Interface Baud Rate Data Format/Notes
Table 3-1. Indicator Setup Parameters (Continued)
STX (02h) Polarity:
= Positive
< – > = Negative
Weight: 7 digits, right-justified, dummy
zeroes, decimal point with no leading
zeroes except for leading zero
immediately preceding the decimal point.
Leading zeroes transmitted as spaces.
G = gram
K = kilogram
L = pound
T = ton (short)
= ton (metric),
grain, ounce or none
G for Gross
N for Net
Status:
= valid
I = Invalid
M = Motion
O = Over/under range
or
or
SOT (01h) “R” (52h)
Seven bytes of numeric data.
EOT (04h)