Rice Lake DWM-IV Weighmeter Series 9 Setup Manual - Manual (Page 23)

21
Error Messages
Error Messages Explanation
CAP OL Over Capacity, weight value exceeds the full scale capacity
ADC UL Input load cell signal is too low or reversed, load cell or load cell -cable is faulty
ADC OL Input load cell signal is too high, load cell or load cell -cable is faulty
NOT CAL Scale is Not yet Calibrated
RMT DSP
Will be displayed on Remote Display Unit when there is no signal from th e Main
Display
RMT OPE
Will be displayed on Remote Operation Unit when there is no signal from the Main
Display
SPAN OL Maximum calculated span count is greater than m aximum ADC Chip count
LO BAT Insufficient battery voltage level. Need to re -charge the battery
- - - - - - -
Display if Power On Zero fails. Need to unload the scale or optional press Zero
Key if power on zero weight is within allowable zero r ange
S.TOTAL
Displayed before entering the password if Sub Total printing is pending. Need to
press ‘Shift’+’Print’ to print the Sub Total and ‘Shift’+’G/N’ to print the Grand Total
G.TOT AL
Displayed before entering the password if Grand Total printing is pending. Need to
press ‘Shift’+’G/N’ to print the Grand Total
Jumper Settings
Reference Table For Jumpers
JP-1 Calibration Enable
JP-2 Reserved
JP-3 Not in use
JP-4 Not in use
JP-5 Not in use
JP-6 to set Excitation Voltage to 5V (Use to conserve power d uring battery operation)