Rice Lake CW-90X Over/Under/Washdown Checkweigher - Ethernet - Manual (Page 14)

10 Ethernet TCP/IP Card Installation Manual
4.0 WLAN Installation and Configuration
Before installing this option, you must contact your IT administrator to obtain network communication
protocol codes and have a RS-232 communications cable or regular comm port cable available to run
between your PC and the indicator while installing and setting up the wireless network.
The optional Lantronix® WiPort™ (WLAN - Wireless Local Area Network) wireless networking device comes
in two sizes. The larger size card (PN 98057) can be installed in the 920i, 820i, 720i, and 520 indicators. The
smaller size card (PN 108671) can be installed inside the 820i, 720i, CW-90/90X, iQube, and iQube 2 products.
Both options can be used for real-time data transmission to warehouse management systems. The
Windows®-based configuration software, DeviceInstaller™ is required for installation/setup and is available on
the CD that comes with the kit. The WLAN option can be factory installed or can be purchased separately and
installed on site.
Figure 4-1. WLAN board
Note
PN Description (quantity)
14822 Screw, MACH 4-40NCx1/4 (2)
52342 Label Roll, 4.00x1.25 (1)
72763 CD, Ethernet (1)
97789 Card, Dual Wireless/RS-232 (1)
98357 Antenna, 2.4GHz 802.11b/g (1)
Table 4-1. PN 98057 Parts Kit
PN Description (quantity)
106103 Board Assy, Wi-port option (1)
72763 CD, Ethernet (1)
95356 Post, PCB Support 1/2” (2)
98357 Antenna, 2.4GHz 802.11b/g (1)
Table 4-2. PN 108671 Parts Kit