Rice Lake BCi Belt Scale - Calibration Guide - Manual (Page 14)

10 BCi In-Motion Belt Scale System
15. Press the Yes softkey to accept that value.
16. Repeat the test until the new span percent error is very near zero and then accept the new span value by
pressing the Yes softkey.
5/30/2013 09:32AM
No Yes
SCALE #1
Progress
Test Time
Test Accumulator
Old Span Error %
Span Error %
18.8
62
95.00
0.10
Accept New Span Value
Figure 3-20. Accept New Span Value
17. Press Exit until back at the integrator weigh screen.
3.2.3 Material Calibration
Use this calibration mode to calibrate the scale with a known amount of material. The material must be
pre-weighed or post weighed.
To perform a material calibration, choose the Material Cal softkey and follow the same steps as a Span Calibration
and instead of entering a test weight value, enter the weight of the material used in tons.