Rice Lake BCi Belt Scale - Calibration Guide - Manual (Page 12)

8 BCi In-Motion Belt Scale System
3. Press the Start softkey
5/30/2013 09:18AM
Exit => Start
SCALE #1
Progress
Test Time
Test Accumulator
Old Span Error %
Span Error %
6.2
0.00
2.55
0.00%
Figure 3-14. Start Auto Cal with Test Weights
4. The Auto Cal test will run, and progress is shown on the screen. A prompt to enter a test weight value will
display.
5/30/2013 09:35AM
End Home
SCALE #1
Progress
Test Time
Test Accumulator
Old Span Error %
Span Error %
18.8
62
0.00
Enter Test Weight Value
=> 10.0
Cancel
Figure 3-15. Enter Test Weight Value
5. Press the CLR key on the integrator to clear off the current value, enter a new test weight value using the
numeric keypad.
6. Press the enter key on the integrator to accept the next test weight value. After the test the test weight value
is entered, the new span error is displayed.
7. Press the Yes softkey to accept that value.
8. Repeat the test until the new span percent error is very near zero and then accept the new span value by
pressing the Yes softkey.
5/30/2013 09:32AM
No Yes
SCALE #1
Progress
Test Time
Test Accumulator
Old Span Error %
Span Error %
18.8
62
95.00
0.10
Accept New Span Value
Figure 3-16. Accept Span Value
9. Press the Exit softkey to exit back to the integrator weigh screen.