Rice Lake 920i Installation Manual V3.07 - Manual (Page 96)

90 920i Installation Manual
SP.COAST#n Pulse counter coast number
SP.TRIP#n Trip HIGHER, LOWER, INBAND, OUTBAND
SP.BANDVAL#n Band value number
SP.HYSTER#n Hysteresis number
SP.PREACT#n Preact type OFF, ON, LEARN, FLOW
SP.PREVAL#n Preact value number
SP.PREADJ#n Preact adjustment percentage number
SP.PRESTAB#n Preact learn stability number
SP.PCOUNT#n Preact learn interval number
SP.TOLBAND#n Target tolerance number
SP.TOLCNT#n Tolerance count number
SP.BATCH#n Batch step enable OFF, ON
SP.CLRACCM#n Clear accumulator enable OFF, ON
SP.CLRTARE#n Clear tare enable OFF, ON
SP.PSHACCM#n Push accumulate OFF, ON, ONQUIET
SP.PSHPRINT#n Push print OFF, ON, WAITSS
SP.PSHTARE#n Push tare OFF, ON
SP.ALARM#n Alarm enable OFF, ON
SP.NAME#n Setpoint name number NONE, 1–60
SP.ACCESS#n Setpoint access OFF, ON, HIDE
SP.DSLOT#n Digital output slot NONE, SLOTx
SP.DIGOUT#n Digital output BITx
SP.SENSE#n Digital output sense NORMAL, INVERT
SP.BRANCH#n Branch destination 0, 1-100
SP.RELNUM#n Relative setpoint number 1–100
SP.START#n Starting setpoint 1–100
SP.END#n Ending setpoint 1–100
SP.DISLOT#n Digital input slot NONE, SLOTx
SP.MASK#n Digital input mask number
SP.NSAMPLE#n Number of samples number
SP.TIME#n Trip time hhmm
SP.DURATION#n Trip duration hhmmss
SP.VUNDER#n Underrange value number
SP.VOVER#n Overrange value number
SP.DUNDER#n Underrange digital output BITx
SP.DACCEPT#n Accept digital output BITx
SP.DOVER#n Overrange digital output BITx
BATCHNG Batching mode OFF, AUTO, MANUAL
SP.ENABLE#n Setpoint enable ON, OFF
For setpoint commands ending with “#n”, n is the setpoint number.
Command Description Values
Table 9-6. SETPNTS Serial Commands (Continued)