Rice Lake 920i FlexWeigh Systems - 101 - Manual (Page 14)

10 System 101 Basic Filler
3.5 Modifying the Filling Speeds
Use the following steps to modify the filling speeds.
1. From the Main Setup Menu Screen , press the Setup Password softkey (a password is not required).
2. Press the More=> softkey to access the second and third menu screens.
Figure 3-7. Setup Main Menu Screen #2
3. Press the Single Speed Enabled, Dual Speed Enabled or Parallel Speed Enabled softkey.
4. The system will toggle between the three modes of operation (see Section 4.3 on page 18) and will display
the selected filling speed.
3.6 Modifying the Auto Tare
Use the following steps to modify the auto tare.
1. From the Main Setup Menu Screen , press the More=> softkey to access the second setup menu screen.
Figure 3-8. Auto Tare Softkey
2. Press the Auto Tare Enabled or Auto Tare Disabled softkey which allows the operator to enable or disable the
auto tare feature. The system will toggle between the two modes of operation.
3.7 Modifying Auto Print
Use the following steps to modify the auto print.
1. From the Main Setup Menu Screen , press the More=> softkey to access the second setup menu screen.
2. Press the Auto Print Enabled or Auto Print Disabled softkey. The system will toggle between the two modes
of operation.
Figure 3-9. Auto Print Disabled Softkey
02:15PM SCALE #1
Auto Tare
Enabled
<= More
Setup Menu:
136.8 SCALE #1
Gross
Lb
SETUP MENU
More => Dual Speed
Enabled
Auto Print
Disabled
SETUP MENU
Program: Express 101 (V 1.00)
ID #1 (disabled)
Start O Zero Tol
ID #2 (disabled) Resume O Fill Copt
Dual Speed (enabled) Reset O Slow Fill
Auto Tare (enabled) Stop O Fast Fill
Auto Print (disabled)
Delay After Discharge (sec) :30
04/27/2011
Auto Tare
Enabled
Auto Print
Disabled