Rice Lake 920i Bulkweigher 107 - 108 - 109 - Manual (Page 15)

Setup Menu 11
3.1 Setup Menu
The 920i Flexweigh Systems Bulkweigher has various setup parameters. They are explained in detail in the follow-
ing sections.
3.1.1 Entering the Setup Menu
Note
The front panel E-Stop button must be in the stopped position (pushed in) to enable any of the following key-
pad entries.
Press the Setup Menu softkey (shown in Figure 5-1) on the main menu screen, and the system displays time and
date, setup password and ID softkeys.
04/17/2012 02:25PM SCALE #1
Setup Menu
SCALE #1
Presets
0
Gross
Lb
Accum: (0) 0
Draft Empty Preact Target
1000 lb 5 lb OFF (0) lb 5000 lb
Discharge Gate Closed
Fill Gate Closed
Manual
Receiving
Figure 3-1. Main Startup Menu Screen
3.1.2 Entering a Password
Certain screens can be password protected depending on the user. To access password parameters,
press the
Setup Password softkey.
Setup
Password
If a system password has previously been entered, proceed to step 3.
If no system password has been previously entered, proceed to step 2.
1. Press the Setup Password softkey.
2. The system prompts with Enter New Password .
04/17/2012 02:15PM SCALE #1
Cancel End
Enter New Password:
3
SCALE #1
Gross
Lb
Home
ID #1: (Disabled)
ID #2: (Disabled)
Slow Cycle Time (sec): 45.00
Delay After Fill (sec): 3.0
Delay After Discharge (sec): 3.0
Discharge Delay (sec): 3.0
Subtotal Print: 3
=>
Program: Express xxxx, PN
Setup Menu
Figure 3-2. Setup Menu Enter Password
3. Enter the desired password and press enter on the 920i.
4. The system checks the entered value against the system password and performs one of the following actions:
• Valid entry — displays the setup menu screen and softkeys.
• Invalid entry — momentarily prompts Invalid password and exits this sequence of operation.