Rice Lake Ethernet TCP/IP - Manual (Page 19)

Ethernet TCP/IP Card Installation Manual - WLAN Installation and Configuration 15
Upon a successful connection, the following information is displayed.
Figure 4-9. Display Information for Setup Mode
7. To enter Setup Mode, press Enter within five seconds. Note that the connection will fail if Enter is not
pressed within the five second time limit. The configuration settings display, followed by the setup menu
options. If this happens, repeat Step 5.
8. Select an option on the menu by entering the number of the option in Your Choice? field and press Enter . In
this case, we’re setting up the WLAN options so press 4 and press Enter as shown in Figure 12.
Figure 4-10. Change Setup Screen
View the current configuration by pressing Enter from the Change Setup menu. To enter a value for a parameter,
type the value and press Enter. To confirm a current value, press Enter (without inputted parameters).
9. Enter the desired Topology for the WLAN option.
Figure 4-11. Topology Screen
The two choices are:
• 0 = Infrastructure
• 1 = AdHoc.