Nimh/nicd battery charge/discharge setup, Nimh/nicd battery charge setup – ProgressiveRC 308Duo iCharger User Manual
Page 21
308DUO V1.6.0
Synchronous Balance Charger/Discharger
- 21 -
LiPo/LiIo/LiFe Battery Cycle Setup
Select Program→Cycle to enter Cycle setup interface, after setting click"
" to return to the previous interface.
LiPo/LiIo/LiFe Battery Only Balance Feature
Select Program→Balance Only to enter Balance Only setup interface, after setting click"
" to return to the previous
interface.
Note: Balance Only is the program only to equalize the individual cells through balance port to reduce
the voltage difference.
NiMH/NiCd Battery Charge/Discharge Setup
After adding a program, it will switch to NiMH/NiCd battery in Type option on the MEMORY SETUP interface. Set the
Capacity, the number of cells for NiMH/NiCd battery cannot be set, and the charger sets Auto by default, after editing
all parameters for the program, click"
" to save and return to the previous interface.
As shown in above picture, the program of NiMH, NiCd has the following modes: Charge, Discharge and Cycle.
NiMH/NiCd Battery Charge Setup
Select Program→Charge to enter Charge setup interface.
Note: Charge Mode has Normal and Reflex modes available; use reflex mode to charge the battery, it
can reduce the heat in the battery; please see charging principle on Page38
Cycle Mode:
CHG
→
DCHG(default),DCHG
→
CHG
，
CHG
→
DCHG CHG, DCHG
→
CHG DCHG,
CHG
→
DCHG STO, DCHG
→
CHG STO
Cycle Count:
1-99; default: 3
Delay Time:
0Min-9999Min; default: 3Min
Chg Current:
0.05A-30A; default: 2A
Chg Mode:
Normal (default), Reflex