Oldcastle BuildingEnvelope Solar Shelf - Manual (Page 6)

6 


S U N C O N T R O L - I N S T A L L A T I O N M A N U A L
SOLAR ECLIPSE
CW-250 SEALANT
™
Install CW-2058 cover plate over
anchor once glass is installed.
Attach with (2) FS-322 fasteners.
Seal gap between anchor
and cover plate.
Note:
Typical pressure plates will be installed above
and below cover plate.
See FIGURE 2, page 4 for face cap fabrication.
1/8" GAP
Seal gap between cover plate
and pressure plate typical.
FIGURE 4
1.3 Sealant
6) Clean all surfaces to be sealed using isopropyl alcohol. Then seal cover plate to anchor to
prevent any water infiltration. See FIGURE 4.
7) Pressure plates should be located above and below the cover plate allowing 1/8" joint. This
joint should be cleaned and sealed. See FIGURE 4.