16_shelf – Oldcastle BuildingEnvelope Solar Shelf User Manual

Page 16






S U N C O N T R O L - I N S T A L L A T I O N M A N U A L

SOLAR SHELF

™

SS-114

Wall Mount

SS-115 Panel Retainer

Cut length equals shelf

strut centerline minus 2 5/8".

Drill 7/32" holes at maximum

12" o.c. Locate on upper &

lower "V" grooves.

1/2"

FIGURE 18

12" O.C.

TYP.

Short leg of wall mount

to top of horizontal

NOTE: WALL MOUNT IS

HANDED AND MUST BE

ORIENTED AS SHOWN.

4.5 Fabricate anchor holes in SS-114 wall mount and the SS-115 panel retainer. Two rows of 7/32" dia.

holes should be drilled between each strut at 12" on center or as required by engineer's review.

Holes should be located in SS-115 at 1/2" from both ends. Take care to align holes in both

extrusions. See FIGURE 18.