Oldcastle BuildingEnvelope Solar Shelf - Manual (Page 5)

5 


S U N C O N T R O L - I N S T A L L A T I O N M A N U A L
CW-250 ASSEMBLY
Attach anchor using
(6) 5/16" X 1" hex head
bolts & washers
CW-2058
CW-2059
CW-3
CW-2
Install CW-2059 anchor with
(6) 5/16" bolts, washers &
locknuts prior to installing glass.
FIGURE 3
FS-322
1.2 Assembly
3) Hardware required for attachment of standard anchor (CW-2058) will be contained in the
hardware package, (part. no.12845). This package contains (1) one CW-2059 cover plate,
(6) six 5/16"- 18 x 1" stainless steel hex head bolts, nuts and washers and (4) 3/8"-16 x 1-1/4"
stainless steel hex head bolts, nuts and washers.
4) Attach anchor to mullion by first hooking into tongue of mullion. The 5/16" nuts will next in the
side of the anchor and allow the bolt to be inserted through the stem and anchor and
tightened. Repeat for each of the 6 bolts. See FIGURE 3 (Size and quantity of bolts may
vary based on project requirements, consult engineer for specific job applications).
5) Once system is glazed, install section of CW-17 gasket onto CW-2059 cover plate and install
plate over anchor attaching to mullion using (2) two FS-322 (#12-14 x 1" HWH Drill-Flex
fasteners).
Note: Due to reduced clearance for attachment of anchors, special care must be taken when
installing glass.
Notes:
1) Assembly package part no. 12845 required for
installation.
2) Anchor must be installed prior to glazing.
3) Glass clearance at anchor is reduced to 3/16", so
care should be exercised during installation of glass.
SOLAR ECLIPSE ™