beautypg.com

Shade assembly, Figure 9 – Oldcastle BuildingEnvelope Solar Shelf User Manual

Page 10

background image

10






S U N C O N T R O L - I N S T A L L A T I O N M A N U A L

Louver

Cut Length

FIGURE 9

Outriggers

FS-20 (#10 X 1/2" S.S. button socket head B pt)

fastener. (4) required typical per louver.

Custom designs may vary.

3.1 Fabrication

15) All standard sunshade outriggers are factory drilled for attachment to shade louvers

16) Cut louvers to fit between outriggers per formulas shown on FIGURE 9.

SOLAR ECLIPSE

TM

Fabrication Notes:

enterline minus 11/16" or mull

centerline minus anchor (1/4" std.) minus 3/8" (thickness of two

1) Louver Cut Length = Mull c

standard outriggers) minus 1/16" clearance.

2) Each louver attached to outriggers with (4) FS-20 fasteners.

Custom louvers may require additional fasteners.

3) Note: Number of louvers will vary based on sunshade depth

and project requirements.