Mercedes-Benz M-Class 2007 Owners Manual - Manual (Page 362)

361
Operation
Engine compartment
Adding engine oil
Example ML 350 (ML 320 CDI similar)
1 Filler cap
Example ML 500 (ML 63 AMG similar)
1 Filler cap
̈ Unscrew filler cap 1 from filler neck.
̈ Add engine oil as required. Never over-
fill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.
̈ Screw filler cap 1 back on filler neck.
For more information on engine oil, see
“Technical data” section (
୴ page 543) and
( ୴ page 546).
! Only use approved engine oils and oil filters
required for vehicles with Maintenance System
(U.S. vehicles) or FSS PLUS (Canada vehicles).
For a listing of approved engine oils and oil
filters, refer to the Factory Approved Service
Products pamphlet in your vehicle literature
portfolio, or contact an authorized
Mercedes-Benz Light Truck Center.
Using engine oils and oil filters of specification
other than those expressly required for the
Maintenance System (U.S. vehicles) or
FSS PLUS (Canada vehicles), or changing of oil
and oil filter at change intervals longer than
those called for by the Maintenance System
(U.S. vehicles) or FSS PLUS (Canada vehicles)
will result in engine or emission control system
damage not covered by the Mercedes-Benz
Limited Warranty.
! Excess oil must be siphoned or drained off.
It could cause damage to the engine and/or
catalytic converter (gasoline engine) or the oxi-
dation catalyst (diesel engine) not covered by
the Mercedes-Benz Limited Warranty.