Mercedes-Benz M-Class 2007 Owners Manual - Manual (Page 288)

287
Controls in detail
Loading
Removing blind
1 Release button
2 Blind
̈ Roll the blind up ( ୴ page 286).
̈ Push release button 1.
̈ Pull blind 2 to the left against the
spring pressure until the spring in the
cover audibly engages.
̈ Remove the blind.
Installing blind
̈ Place left side of blind 2 in left mount.
̈ Position right side of blind 2 over right
mount.
̈ Press release button 1 and guide
cover 2 into mount.
̈ Make sure the cargo compartment
cover blind is securely fastened.
Partition net*
i Before removing cargo compartment cover
blind behind the rear seats, fold the left or right
rear seat forward. Afterwards, return the left or
right rear seat into its original position.
i Before installing cargo compartment cover
blind behind the front seats, fold the rear seats
forward.
Warning!
G
Make sure the partition net is properly en-
gaged at top and bottom position and the
tightening belts are securely fastened.
Never use a damaged partition net.
To help avoid personal injury from smaller
objects being thrown around in the occu-
pant compartment during a collision or sud-
den maneuver, always use partition net
when transporting cargo.
The partition net cannot prevent the move-
ment of large, heavier objects into the pas-
senger compartment in an accident. Such
items must be properly secured using the
cargo tie-down rings ( ୴ page 283) in the
cargo compartment floor.
Passenger use of seats behind installed par-
tition net is restricted because of the foot-
well being taken up by the net.