Power windows:synchronizing, door windows, Synchronizing the door windows – Mercedes-Benz M-Class 2007 Owners Manual User Manual

Page 239

238

Controls in detail

Power windows

Fully opening the door windows
(Express-open)

Press switch

1, 2, 3, or 4

and release.

The corresponding door window opens
completely.

Fully closing the door windows
(Express-close)

Pull switch

1, 2, 3, or 4

and release.

The corresponding door window closes
completely.

If the upward movement of a door window
is blocked during the closing procedure,
the door window will stop and open slight-
ly.

Remove the obstruction.

Pull the respective power window
switch past the resistance point again
and release.

Stopping door windows during
Express-operation

Press or pull respective power window
switch again.

Synchronizing the door windows

The door windows must be resynchronized

after the battery was disconnected

if the door windows cannot be fully
opened (Express-open) or closed
(Express-close)

Close all doors.

Pull and hold power window switch

2, 3, or 4 (

Once a door window is closed com-
pletely, hold the respective switch for
approximately 3 seconds.

The door window is synchronized.

Warning!

Driver’s door only:

If within 5 seconds switch is again pulled

past the resistance point and released, the

automatic reversal will not function.

If the door window still does not close when

there is no obstruction, pull and hold the respec-
tive power window switch. The door window will
then close without the obstruction sensor
function.

Each door window must be resynchronized

separately.