Mercedes-Benz M-Class 2007 Owners Manual User Manual
Page 318
317
Controls in detail
Useful features
Programming the integrated remote
control
Step 1:
̈
Switch on the ignition (
Step 2:
̈
If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons
2 and 4 and release
them only when indicator lamp
1
begins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.
Step 3:
̈
Hold end of the hand-held remote
control
5 of the device you wish to
train approximately 2 to 5 in
(5 to 12 cm) away from the signal
transmitter button (
2, 3 or 4) to be
programmed, while keeping the indica-
tor lamp
1 in view.
Step 4:
̈
Using both hands, simultaneously
press hand-held remote control
button
6 and the desired signal trans-
mitter button (
2, 3 or 4). Do not
release the buttons until step 5 is com-
pleted.
Indicator lamp
1 will flash, first slowly
and then rapidly.
When programming a garage door opener,
park the vehicle outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health.
All exhaust gas contains carbon monoxide
(CO), and inhaling it can cause unconscious-
ness and possible death.
i
Indicator lamp
1 flashes immediately the
first time the signal transmitter button is
programmed. If this button has already been
programmed, the indicator lamp will only start
flashing after 20 seconds.
୴୴