Controls in detail, Driving systems – Mercedes-Benz R-Class 2010 Owners Manual User Manual
Page 152
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising from returning to the preset speed
could cause an accident and/or serious injury
to you and others.
X
Briefly pull the cruise control lever in
direction of arrow ? (
If no speed is stored, the current speed is
set and stored.
X
Remove your foot from the accelerator
pedal.
X
Depress the brake pedal.
or
X
Briefly push the cruise control lever in
direction of arrow = (
The cruise control speed segments in the
speedometer dial will go out and the
following message appears briefly in the
multifunction display:
DISTRONIC Off
The last set speed is stored for later use.
The last stored speed is deleted from memory
when the engine is turned off.
The Distronic switches off automatically
when you depress the brake pedal or you
engage the parking brake. In this case, the
cruise control speed segments in the
speedometer dial will go out.
The Distronic also switches off automatically
when
R
the vehicle speed falls below 20 mph
(30 km/h)
R
the ESP
®
is in operation
R
the ESP
®
is switched off with the ESP
®
switch
R
the ESP
®
has switched off due to a
malfunction
R
you shift the automatic transmission into
neutral position
N while driving
The cruise control speed segments in the
speedometer dial goes out and an acoustic
warning will sound. Observe additional
messages in the multifunction display that
may appear.
Distronic switches off and releases the brakes
when the vehicle decelerates below the
minimum speed of 20 mph (30 km/h) by
operation of the system. At that time the
driver must apply the brakes in order to
reduce vehicle speed further or bring it to a
stop.
Depressing the accelerator pedal does not
deactivate the Distronic. After a brief
acceleration (e.g. for passing), the Distronic
will resume the last set speed.
You can set the specified following distance
for Distronic by varying the time setting
between 1.0 and 2.0 seconds. Using this time
setting and the current speed of your vehicle,
Distronic calculates and sets the required
following distance to the preceding vehicle.
The set distance will be shown in the
multifunction display.
It is up to the driver to exercise discretion to
select the appropriate setting given road
conditions, traffic, driver’s preferred driving
style and applicable laws and driving
recommendations for safe following distance.
150
Driving systems
Controls in detail
251_AKB; 4; 52, en-US
d2ureepe,
Version: 2.11.8.1
2009-03-23T09:22:52+01:00 - Seite 150