beautypg.com

Adjusting the instrument cluster illumination, Resetting trip odometer, Tachometer – Mercedes-Benz R-Class 2010 Owners Manual User Manual

Page 125: Control system, Introduction, Multifunction steering wheel, Controls in detail

background image

Adjusting the instrument cluster

illumination

X

To brighten illumination: Press and hold

button = until the desired level of
illumination is reached.

X

To dim illumination: Press and hold

button : until the desired level of
illumination is reached.

i

The instrument cluster illumination is

dimmed or brightened automatically to suit
ambient light conditions.
The instrument cluster illumination will also
be adjusted automatically when you switch
on the vehicle’s exterior lamps.

i

With the exterior lighting switched on, the

brightness of the switches in the center
console will also be adjusted when using
button : or =.

Resetting trip odometer

X

Make sure you are viewing the standard
display (

Y

page 126) in the multifunction

display.

X

Press and hold the reset button in the
instrument cluster (

Y

page 122) until the

trip odometer is reset.

Tachometer

The red marking on the tachometer
(

Y

page 29) denotes excessive engine speed.

!

Avoid driving at excessive engine speeds,

as it may result in serious engine damage
that is not covered by the Mercedes-Benz
Limited Warranty.

To help protect the engine, the fuel supply is
interrupted if the engine is operated within
the red marking.

Control system

Introduction

The control system is activated as soon as the
starter switch is in position

1 (

Y

page 79).

The control system enables you to call up
information about your vehicle and to change
vehicle settings.
For example, you can use the control system
to find out when your vehicle is next due for
maintenance service, to set the language for
messages in the instrument cluster display,
and much more.

G

Warning!

A driver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
For your safety and the safety of others,
selecting features through the multifunction
steering wheel should only be done by the
driver when traffic and road conditions permit
it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximately
14 m) every second.

The control system relays information to the
multifunction display.

Multifunction steering wheel

The displays in the multifunction display and
the settings in the control system are
controlled by using the buttons on the
multifunction steering wheel.

Control system

123

Controls in detail

251_AKB; 4; 52, en-US
d2ureepe,

Version: 2.11.8.1

2009-03-23T09:22:52+01:00 - Seite 123

Z

This manual is related to the following products: