beautypg.com

Transfer case, Instrument cluster, Introduction – Mercedes-Benz R-Class 2010 Owners Manual User Manual

Page 124: Activating the instrument cluster, Controls in detail

background image

Transfer case

The vehicle is equipped with all-wheel drive
(4MATIC). Both the front and rear axles are
powered at all times when the vehicle is being
operated.

!

Only conduct operational or performance

tests on a two-axle dynamometer. If such
tests are necessary, contact an authorized
Mercedes-Benz Center. You could
otherwise seriously damage the brake
system or the transfer case which is not
covered by the Mercedes-Benz Limited
Warranty.

!

Because the ESP

®

operates

automatically, the engine and ignition must
be shut off (SmartKey in starter switch
position

0 or 1 or KEYLESS-GO start/stop

button in position

0 or 1) when the parking

brake is being tested on a brake test
dynamometer. Such testing should be no
longer than 10 seconds.
Active braking action through the ESP

®

may otherwise seriously damage the brake
system which is not covered by the
Mercedes-Benz Limited Warranty.

Instrument cluster

Introduction

For a full view illustration of the instrument
cluster, see “Instrument cluster”
(

Y

page 28).

G

Warning!

No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see
information about your driving conditions,
such as

R

speed

R

outside temperature

R

warning/indicator lamps

R

malfunction/warning messages

R

failure of any systems

Driving characteristics may be impaired.
If you must continue to drive, do so with added
caution. Contact an authorized Mercedes-
Benz Center as soon as possible.

:

To dim instrument cluster illumination

;

Reset button

=

To brighten instrument cluster
illumination

For information on changing the instrument
cluster settings, e.g. the language, see
(

Y

page 132).

Activating the instrument cluster

The instrument cluster is activated when you

R

open the driver’s door

R

switch on the ignition

R

press button :, ; or =

i

Opening the driver’s door or pressing

button :, ; or = without switching on
the ignition activates the instrument
cluster illumination only for 30 seconds.

122

Instrument cluster

Controls in detail

251_AKB; 4; 52, en-US
d2ureepe,

Version: 2.11.8.1

2009-03-23T09:22:52+01:00 - Seite 122

This manual is related to the following products: