Losi LOSB0101 User Manual

Page 7

Battery Pack(s)

To install the battery pack remove the battery hold-down strap by removing the clip from the front mounting boss, and then, while

lifting the strap, pulling forward in one motion.

Note: When using a 7-cell battery pack you must remove one of the foam battery spacers for the battery pack to fit properly

into the compartment.

After you have inserted the fully-charged battery pack reinstall the battery hold-down strap.

Notice that the battery hold-down has a flat side while the other side has strengthening ribs; the flat side should be facing

down to the battery.
Insert on an angle into the rear support, and then down on the front pin and secure it with the previously removed clip.

Note: Please read the entire manual to gain a full understanding of the Speed-T vehicle,

your Xcelorin brushless system, fine-tuning the setup and performing maintenance.



1. Read the safety precautions found on page 3. This is important for your safety and

prevention of personal injury.



2. Charge the battery pack you have chosen (NOT INCLUDED). Refer Manufacturer’s

Supplied instructions for battery charging information.



3. Install the AA batteries into the MTX Pro Transmitter (see page 11). Use alkaline or

rechargeable batteries only (NOT INCLUDED).



4. Install the battery pack (see previous page). This battery pack should be fully charged

before installation.



5. Turn on the transmitter and then the vehicle. It is a good practice to

turn on the transmitter before the vehicle and turn it off after the vehicle has

been turned off.



6. Please Note! Default profile of the ESC does not provide FULL THROTTLE. Please refer

to page 18 for information on profiles.



7. Check Steering (see page 14). Verify that the servo is functioning properly.



8. Driving the Speed-T (see page 21).



9. Performing maintenance of the Speed-T. Refer to Tuning, Adjusting, and Maintenance

of the Speed-T on page 22.

Quick Start