beautypg.com

Rebuilding/refilling the shocks, Tools needed – Losi LOSB0020 User Manual

Page 13

background image

Rebuilding/Refilling the Shocks

Rebuilding/Refilling the Shocks

Step 1.
After removing the shock,
push up on the lower spring
cup and snap it off of the
shaft. Remove the spring.

NOTE: If you only wish to change
or fill the shock fluid, skip to step 6.

Turn the shock upside down
and, using the included shock
tool, remove the black shock
cartridge/shaft assembly from
the shock body by turning it
counterclockwise.

Step 2.

Step3.
Remove the 1/4" nut by turning it
counterclockwise. Remove the
piston and washer. Remove the
old cartridge. Put a drop of shock
oil on the shock shaft before
installing new shock cartridge.

Hold here with needle-nose pliers

Tools Needed

Step 4.
Install washer onto the shock
shaft until it stops. Slide the
shock piston onto the shaft
against the washer. Reinstall
1/4" nut and tighten by
turning it clockwise.

Be sure to
reinstall
washer

Step 5.
If you plan on completely changing
the shock fluid (suggested), dump
out the old fluid from the shock
body before reinstalling the
cartridge/shaft assembly. Pull the
shaft out so that the piston is next
to the cartridge and reinstall the
assembly into the shock body;
tighten in a clockwise direction.

Step 6.
Note: If you are just refilling your
shocks, be sure to use
Losi 30wt Silicone
Shock Fluid (LOSA5224).
Remove the shock cap and the
small button head screw and
washer in the top of it.
Carefully fill the shock body with
fluid to the top. Move the shaft
up and down slowly to remove
bubbles. Top off with oil if needed.

Step 7.
Holding the shock upright, push
the shock shaft in slowly until it
bottoms out. While holding the
shock shaft in this position,
replace the small screw and
washer in the shock top. If fluid
leaks around the threads of the
cartridge, it is probably not
tight enough.

Step 8.
Slide the spring over the
shock body against the
shock adjuster nut. Slide
the lower shock cup onto
the shock shaft and snap it
onto the shock end being
sure that it seats on the
mount. Reinstall the shock.

"snap!"

"snap!"

"snap!"

A6234

B2900

B2815

B2876

B2820

B2840

B2900

B2875

B2948

B2840

B2900

B2900

B2840

LOSA5224

30wt

Page 13