Losi LOSB0020 - Manual (Page 10)

Replacing the 2-Speed Gears
Replacing the Clutch Bell
Use a 3/32” wrench (provided) to remove the retaining screw (turn counterclockwise) while firmly
holding the flywheel with a pair of pliers. Remove the screw, washers and clutch bell, being careful not
to lose any shims that may be used. Remove the ball bearings and brush any loose dirt away from the
bearing faces. Put only ONE drop of oil on the inside face (the side facing away from the clutch shoes)
near the inner race of the bearing. Install the bearings into the new clutch bell. Before replacing the
clutch bell, wipe out the inside with motor spray, lacquer thinner or a similar cleaner (do not use fuel or
oil-based solvents). Replace the clutch bell and secure with the retaining screw in the same manner used
to remove it.
Note: Do not over-tighten the screw, as it is not necessary.
Page 10
Be sure to replace the one-way
bearing in the same direction
as removed.