Kontron KISS 2U Short KTQ67 - Manual (Page 29)

8. Installation and Removal KISS 2U Short V2 – User’s Guide (V1.00)
3. Unscrew the knurled screws (the cover fastening screw on the front side and the two knurled screws on the rear side)
which secure the cover (see Fig. 25 and Fig. 26).
Fig. 25: Unscrew the cover fastening knurled screw on the front side
Fig. 26: Unscrew the knurled screw on the rear side
4. Pull the cover out a little bit (Fig. 27) to release the cover centering and fixing brackets (Fig. 23, pos.3, 4 and 5) from
the retaining plates of the chassis (Fig. 7und Fig. 8, pos. 4 und pos. 9).
Fig. 27: Pull out the cover centering and fixing brackets from the retaining plates of the chassis.
5. Lift the cover up (on the rear edge) and remove it (Fig. 28).
Fig. 28: Removing the cover
www.kontron.com 27