Installation and removal, Attaching the rubber feet – Kontron KISS 2U Short KTQ67 User Manual
Page 27
8. Installation and Removal
KISS 2U Short V2 – User’s Guide (V1.00)
8.
Installation and Removal
8.1. Attaching the Rubber Feet
If the system is used as desktop version, attach the supplied rubber feet to the device.
Before attaching the rubber feet, ensure that your system is switched off and disconnected from the
main power source.
To attach the rubber feet, proceed as follows:
1. Turn off the system and disconnect it from the mains power source.
2. Turn the device upside down on a table or desk.
3. Ensure that all components are securely installed and that the device cover has been screwed on tightly.
4. Remove the protective film from the rubber feet.
5. Stick the four rubber feet to the underside of the device.
www.kontron.com
25
- CP3003-SA uEFI BIOS (72 pages)
- CP3003-SA (36 pages)
- CP3002 (38 pages)
- CP3002-RC uEFI (64 pages)
- CP-RIO3-05 (42 pages)
- CP3002-RC (30 pages)
- CP342 (52 pages)
- CP930 (46 pages)
- CP932 (52 pages)
- CP346 (72 pages)
- CP384 (66 pages)
- CP383 (74 pages)
- CP382 (58 pages)
- CP381 (60 pages)
- CP372 (64 pages)
- CP371 (60 pages)
- CP-RIO3-04S (38 pages)
- CP390 (36 pages)
- CPS3410 (9 pages)
- CPS3402 (9 pages)
- CPS3105 (9 pages)
- CPS3101 (9 pages)
- CPS3003-SA (19 pages)
- PB-SIO4 (34 pages)
- PB-SIO4A (34 pages)
- PB-DOUT8 (34 pages)
- VMOD-2 (82 pages)
- VSBC-32 (110 pages)
- VM42 (62 pages)
- Bootstrap Loader (24 pages)
- VMP1 with Netbootloader (120 pages)
- VMP1 (106 pages)
- NetBootLoader (86 pages)
- VMP2 (142 pages)
- VMP3 (154 pages)
- CP-RIO6-923 (32 pages)
- CP-RIO6-923-F (32 pages)
- CP-RIO6-001 (28 pages)
- CP-RIO6-001-HD-VGA (46 pages)
- CP-RIO6-M (20 pages)
- CP-RIO6-B (28 pages)
- CP6925 (42 pages)
- CP6002 uEFI BIOS (76 pages)
- CP6002 IPMI (40 pages)
- CP6002 (42 pages)