Kontron AM4204 - Manual (Page 32)

17 AM4204
www.kontron.com
r - reset system
Starting shell
Give root password for system maintenance
(or type Control-D for normal startup):
System Maintenance Mode
BusyBox v1.4.1 (2009-07-23 18:10:23 CEST) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
# serialcfg
usage: serialcfg fru1/fru2/fru3/fru4
Enable T5516 serial line for FRU1-4, i.e. AMCB1-B4
usage: serialcfg FILENAME
Enable serial line with portstate config file FILENAME
#
serialcfg fru1
Serial AMCB1 to RTM rotary switch channel 4
Enabling ports for FRU 1
3 Set the RTM’s rotary switch as indicated by the serialcfg tool output (in this example switch channel 4).
4 Close AM4204 handle or power up.
5 Wait for boot process to complete. Login is not required by default:
BusyBox v1.2.1 (2008.09.15-08:10+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
~ #
3.4.2 Access over Ethernet Interface
The AM4204 has a pre-configured fixed IP address on the front port SFP1 (QLM3 0).
The IP address is: 192.168.0.100 (eth6 with default settings).
This interface requires either a fiber or a copper SFP. The IP address of the connected host must be
configured accordingly.
The AM42040 can also be accessed by using the Ethernet Interface AMC port 0 (eth0).
By default, DHCP is configured for this Interface.
3.4.3 Using SoL over AMC Port 0 on AM4204
3.4.3.1 Requirements
• AM4204
• ATCA carrier or uTCA System providing access to AMC connector port 0
• Linux host with Ethernet interface