Kontron AM4210 User Manual
Page 74
59
www.kontron.com
KCS: Reading boot image number : Image 0
KCS: Reading interface settings: front x1 XAUI, p8..11 x4 GE
KCS: Reading PCIe settings : Disabled
KCS: Reading PCIe clock source : local
KCS: Reading ethaddr : 00:a0:a5:63:d4:0a
KCS: Reading serial# : 9010006140
BIST check passed.
Starting PCIE
PCIe: Waiting for port 1 link
PCIe: Port 1 link active, 4 lanes
PCIe: port=1, first_bus=0, last_bus=0
Net: e1000_eth0, e1000_eth1, octeth0, octeth1, octeth2, octeth3, octeth4
autoboot in 5 seconds...
press 'bootstopkey' phrase to abort
ß Enter ‘stop’ here
MMC watchdog stopped
Kontron T5516#
• Get proper network settings
Kontron T5516#
bootp
• Set the TFTP server IP
Kontron T5516#
setenv serverip
• Unprotect flash memory
Kontron T5516#
protect off all
Un-Protect Flash Bank # 1
Kontron T5516#
• Flash new Linux kernel/rootfs binary
Kontron T5516#
run data1a_flash_update
...........................................................................................
...........................................................................................
....................................................................... done
Erased 253 sectors
Copy to Flash... done
Kontron T5516#
• Check the updated image
Kontron T5516#
run activate_image0
In case the updated image boots properly, image1 can be updated as described above using the same image
file with the following commands:
• run data1a_backup_flash_update
• run activate_image1
Note:
The data1a_backup_flash_update command will update image0 when image1 has been booted!