3 access via front panel ethernet interface, 4 using sol over amc port 0 on am4210, 1 requirements – Kontron AM4210 User Manual
Page 34: 2 configure iol (ipmi over lan), Access via front panel ethernet interface, Using sol over amc port 0 on am4210
19
www.kontron.com
BusyBox v1.2.1 (2008.09.15-08:10+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
~ #
3.4.3
Access via Front panel Ethernet Interface
The AM4210 can be accessed by using the Ethernet Interface port0 (eth0).
By default, DHCP is configured for this Interface.
There is also a possibility to access the AM4210 using the SFP+ on the front plate. This interface is not
configured by default and must be setup accordingly by editing the file /mnt/etc/rc.local.
3.4.4
Using SoL over AMC Port 0 on AM4210
3.4.4.1
Requirements
• AM4210
• ATCA carrier or uTCA System providing access to AMC connector port 0
• Linux host with Ethernet interface
• SFP+ module (optical or copper) for Ethernet connection to the Linux host
• ipmitool v1.8.9
3.4.4.2
Configure IOL (IPMI over LAN)
Connect to the AM4210 via telnet
Check board information (optional)
~ # /mnt/bin/ipmitool mc info
Device ID : 6
Device Revision : 0
Firmware Revision : 5.24
IPMI Version : 1.5
Manufacturer ID : 15000
Manufacturer Name : Kontron
Product ID : 5516 (0x158c)
Device Available : yes
Provides Device SDRs : yes
Additional Device Support :
Sensor Device
FRU Inventory Device
IPMB Event Receiver
IPMB Event Generator
Chassis Device
Aux Firmware Rev Info :
0x00