1 introduction, Introduction, 1introduction – Kontron mITX-E38 User Manual
Page 7
KTD-N0903-A
Page 5
Introduction
mITX-E38 Users Guide
1
Introduction
This manual describes the mITX-E38 boards made by KONTRON Technology A/S. The boards will also be
denoted E38.
The E38 boards are based on Intel Atom E38xx SOC (System On Chip) and will be available in three versions
having 1, 2 or 4 cores. The differences between the three types of boards are listed in this table:
Feature
mITX-E3815
mITX-E3826
mITX-E3845
Bay Trail SOC
E3815 (1 core) E3826 (2cores) E3845 (4 cores)
Core speed
1,46GHz
1,46GHz
1,91GHz
Total Design Power
5W
7W
10W
Integrated cooler
Passive
Passive
Active
Graphics
2x DP
2x DP
DP + LVDS
Onboard eMMC
-
-
16GB TLC NAND
SD Card slot
-
Yes
Yes
TPM
-
-
Yes
COM ports
2x RS232
6x RS232
6x RS232
USB
1x USB3.0/2.0
3x USB2.0
1x USB3.0/2.0
3x USB2.0
1x USB3.0/2.0
6x USB2.0
Use of this Users Guide implies a basic knowledge of PC-AT hard- and software. This manual is focused on
describing the E38 board’s special features and is not intended to be a standard PC-AT textbook.
New users are recommended to study the short installation procedure stated in the following chapter
before switching-on the power.
All configuration and setup of the CPU board is either done automatically or manually by the user via the
BIOS setup menus. Only exceptions are the “Clear CMOS” Jumper and the “Always On” jumper.
Latest revision of this manual, datasheet, BIOS, drivers, BSP’s (Board Support Packages), Mechanical
drawings (2D and 3D) can be downloaded from here: