Kontron mITX-E38 - Manual (Page 10)

KTD-N0903-A Page 8 System Specification
mITX-E38 Users Guide
3 System Specifications
Component main data 3.1
Form factor mITX (miniITX) 170,18 mm by 170,18 mm
Processor Intel Bay Trail FCBGA1170 Type 3 27x25mm 0.593 Ball Pitch.
Three versions available:
E3815 (1 core), 1,46GHz, 5W
E3826 (2 core), 1,46GHz, 7W
E3845 (4 core), 1,91GHz, 10W
Memory 1x DDR3L SODIMM socket supporting single-channel unbuffered DDR3L 1066/1333MHz
(PC3-8500/PC3-10600). Up to 4GB (Intel specification) however Kontron has qualified
8GB. (ECC not supported).
Flash eMMC 16GB TLC Nand. E3845 only.
SD card slot
1x SD Card Slot, SD Card 3.0 interface. E3826 and E3845 only.
•
Up to 832Mbits per second data rate using up to 4 parallel data lines.
• Transfers the data in following UHS-I modes: HS and DDR50.
• Cyclic Redundancy Check CRC7 for command and CRC16 for data integrity.
• Designed to work with I/O cards, Read-only cards and Read/Write cards.
• Supports Read wait Control. SDIO only validated with WIFI devices.
SATA 2x SATA Gen2 (3.0/1.5Gb/s). SATA1 and SATA2.
Notes: RAID is not supported. SATA1 shared with mSATA, so that if mSATA is installed
then the SATA1 is disabled.
LAN Support 2x 10/100/1000Mbits/s LAN (LAN1 & LAN2) based on Intel® Pearsonville I211AT
• PXE Netboot supported.
• Wake On LAN (WOL) supported
Serial 2x Serial ports (RS232) (COM1 – COM2), via ITE8516
4x Serial ports (RS232) (COM3 – COM6), via ITE8517, E3826 and E3845 only.
USB • 1x USB3.0/2.0 (Rear IO area, single USB port connector)
• 2x USB2.0 (Rear IO area, dual USB port connector)
• 1x USB2.0 (available in mPCIe slot)
• 3x USB2.0 (Front Panel Connector and USB6 connector) E3845 only.
DP DP (DisplayPort) v1.1a. Intel® Gen7 Graphics, OpenGL 3.0, OpenCL 1.2, DX11, H.264,
MPEG2, MCV, VC-1, VP8.
2x DP (E3815 and E3826)
1x DP (E3845)
LVDS LVDS panels up to 2 pixels per clock, 24 bit colors (VESA/JEIDA). Based on DP to LVDS
converter type PTN3460BS. E3845 Only.