Kontron mITX-E38 - Manual (Page 30)

KTD-N0903-A Page 28 Internal Connectors
mITX-E38 Users Guide
SATA (Serial ATA) Disk interface (SATA0 – J15, SATA1 – J1) 7.7
The two SATA ports available on the mITX-E38 supports SATA Gen2 (3.0/1.5Gb/s).
Notes: RAID is not supported. SATA1 shared with mSATA, so that if mSATA is installed then the SATA1 is
disabled.
Sata connector pinning: SATA0 and SATA1
PIN Signal Type Ioh/Iol Note
1 GND PWR -
2 SATA* TX+
3 SATA* TX-
4 GND PWR -
5 SATA* RX-
6 SATA* RX+
7 GND PWR -
Signal Description
SATA* RX+ / RX- Host transmitter differential signal pair
SATA* TX+ / TX-
Host receiver differential signal pair
“*” specifies 0, 1 depending on SATA port.
Available cable kit:
PN 821035 Cable SATA 500mm